Adjustment of day / night mode changeover
Menu level 1 | Menu level 2 |
|---|---|
 | |
- The "System services" menu can be retrieved in 30 minutes.
- The "WIFI" menu can be retrieved in 30 minutes.
- The menu can only be used with the following coupled SI-BUS devices:
- SIEGENIA access control system
- IO module smart
Menu level 1 | Menu level 2 | value | |||
|---|---|---|---|---|---|
Function | LED button | Connection to terminal 1 | Additional function | ||
 |  | 4 | Active | Active | – |
 | 5 | Active | Active | Single switchover between Day and Night mode is possible | |
 | 6 | Active | Active | Single switchover from night mode to day mode and back to night mode again is possible | |
 | 1 | Inactive | Inactive | – | |
 | 2 | Inactive | Active | – | |
 | 3 | Active | Inactive | – | |
Prerequisites
- The status LED lights up green.
- The LED button lights up white in day mode or blue in night mode.
- Press the LED button if no LEDs light up.
- To change to menu level 1, press and hold down the LED button for 8 seconds until it light up magenta and emits an acoustic signal.
- To adjust the operating mode of the day / night changeover, press the LED button until it lights up light green.
- For type EA or CA press the LED button 1x.
- For type EB or CB press the LED button 3x.
- To change to menu level 2, press and hold down the LED button for 3 seconds.
- In the menu level 2 the adjusted value flashes first.
- To select the desired function, press the LED button according to the scheme.
- Hold down the LED button for 3 seconds to save the selected function.