Mounting sensor and slider

Use the sensor and the slider for window sashes with oblong holes and cams (1) and for surface-mounted striker plates (2).


  1. Open the window.
  2. Clean the window sash at the installation position. The installation position must be dry, dust-free and grease-free.
  3. Guide the slider with the magnet over the cam.

  4. NOTICE

    notice

    Material damage due to incorrect adhesion

    The sensor can fall off and shatter due to incorrect adhesion.

    1. Clean the installation position so that it is dry and free of dust and grease.
    2. Only use the adhesive pads 1x.
    3. If the adhesive pads have already been used, then use adhesive tape VHB 5925 F from the producer 3M.
  5. To glue the sensor adhesive pad correctly: for left-hand opening windows, fix the sensor so that the marking "L" is visible. For right-hand opening windows, fix the sensor so that the marking "R" is visible.
  6. Glue the sensor adhesive pad to the sensor and press for at least 5 seconds.
  7. Position the sensor on the window sash (1). The marking on the sensor must be flush with the magnet (2). Press the sensor to the window sash for at least 5 seconds.

Teaching in the smart sensor