Installation of ventilation pipe and PVC weather grille

NOTICE

notice

Material damage due to holes in the wall

Concealed cables or pipes can be damaged while drilling the core hole.

  1. Ensure that there are no cables or pipes in the installation area of the wall.
  2. Use a suitable detection device to check for cables and pipes.
  1. Fix the drilling template to the wall. Be mindful of the intervals from the core hole when doing so, Processing dimensions.

  2. NOTICE

    notice

    Material damage due to incorrect angle when drilling the core hole

    If the angle is >1.0°, the ventilation unit cannot be installed.

    1. Drill the core hole to the outside from the room.
    2. Drill the core hole at an angle of 0.0° – 1.0°.
  3. Drill the core hole.
  4. Trim the pipe to the wall thickness, Processing dimensions.

  5. NOTICE

    notice

    Material damage due to incorrect angle of the ventilation pipe

    If the angle is >1.0°, the ventilation unit cannot be installed.

    1. Install the ventilation pipe at an angle of
      0.0° – 1.0°.
  6. Insert the pipe with the plaster cover into the wall.
  7. Insulate the pipe as far as the plaster cover (depending on requirements).
  8. Seal the pipe so that it is airtight to the inside and breathable to the outside.
  9. Apply the sealant to the weather grille.
  10. Position the weather grille and press firmly against the wall. Ensure that the fins are pointing downwards.