Preparation for installation

1

Milling for main lock case

2

Milling for auxiliary box

3

Milling for drive

4

Hole for lever handle

5

Milling for profile cylinder

6

Milling for main striker plate

7

Milling for additional striker plate

8

Milling for magnet

  1. Drill and mill the door leaf and door frame according to the dimension specifications and the general tolerances defined in ISO 2768.
  2. Remove any splinters from routed pockets after milling.
  3. Before installing the product, check the dimensional accuracy of the door and the door frame. Do not install the product in event of warping or damage.
  4. Check the product for damage. Do not install the product if it is bent or damaged.
  5. Route the cable for power supply to the drive from the hinge side of the door leaf to the product without kinks.
  6. If need be, insert the oval magnet bush into the striker plate series 23xx without backing with the magnet facing upwards.